KitchenAid Parts

Lower dishrack roller assembly, gray, (4) required to replace them all. Sold individually

The Dishwasher Rack Adjuster WPW10546503 is a genuine replacement part designed to fix height adjustment issues with your upper rack. The WPW10546503 fits either the left or right sides. It is compatible with Whirlpool, Kenmore, Maytag, Jenn Air, KitchenAid, Ikea, and Kenmore Elite models.

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Consider replacing the idler assembly while you have the dryer apart.

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Microwave incandescent light bulb, 40 Watt. * Special Note* Manufacture recommends unplugging microwave prior to replacing light bulb.

Stop clip for upper dishwasher dishrack. The stop clip prevents the dishrack from sliding all the way out of the dishwasher.

Dryer electric heating element assembly

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Bake element assembly with support brackets

FreshFlow air filter, reduces common food odors in the refrigerator. 15 times more powerful than baking soda. Replace every 6 months

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Consider replacing the belt while the dryer is apart.