KitchenAid Washer/Dryer Combo Parts

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

White touch-up paint

OEM Part - Manufacturer #72017

Washing machine main tub seal

OEM Part - Manufacturer #W10814296

Washer drive block for inner tub. A worn drive block may cause the washer to spin slowly, causing the clothes to be soaked at the end of the cycle. The washer may also make a loud knocking noise at the beginning of the spin cycle.

OEM Part - Manufacturer #WP389140

Heating element wire connector kit for electric dryers. If the wire & connector at the dryer heating element is bad this wire connector kit can be used to repair it.

OEM Part - Manufacturer #279457

Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud

OEM Part - Manufacturer #279827

Shaft for drum support roller, right side

OEM Part - Manufacturer #WPW10359269

Dryer door/washer lid switch kit

OEM Part - Manufacturer #W10820036

Shaft for drum support roller, left side

OEM Part - Manufacturer #WPW10359270

Transmission (gearbox) for direct-drive washing machines. If the gears inside the transmission are worn out, the washer may not spin.

OEM Part - Manufacturer #3360629

The drive coupler can wear out significantly over time. Consider replacing the drive coupler while you have the washer apart.

Dryer foam seal with adhesive backing. This seals goes between the lint chute and the bulkhead. 28 in

OEM Part - Manufacturer #WP339956

5-foot-long rubber fill hose for washing machines. Used for hot or cold water.

OEM Part - Manufacturer #WP89503

Over time, rubber hoses dry out and become susceptible to leaks or bursts. Replace fill hoses every 5 years to reduce the risk of hose failure.

Drain pump mounting bracket

OEM Part - Manufacturer #WP8546127